Hey everyone.
I hope you all are doing well and enjoying your Beavers!
I had my HWH air leveling recalibrated about a year ago at BCS. I was about half a bubble out of center....(story of my life
For a while it would level well after recalibration, using the auto leveling on my 06 Monterey. It didn't seem to work too hard, lowered a side, raised a back or front and finished being level.
Fast forward. I noticed that my bay door would catch the side of the slide out (drivers side) and my bathroom door would swing closed. The computer seemed to be adjusting the coach way more than "normal", but would ultimately flash the red light, suggesting I was level. I was not.
Last week, I returned from a walk to notice the bottom left corner of my windshield was cracked in three places and ran up about two feet towards the roof. The window replacement guy had me adjust manually and then also automatically before he replaced the glass to figure out what was going on.
He noticed than when in travel mode my left front sat lower than right front (from site, not ride height I think), but it also seemed that way at my next site which I felt to be almost level when still in travel mode. He watched the glass as I auto leveled. I wasn't that unlevel and it seemed to be working more than I thought necessary. It was stressing the glass in the left corner, so I returned to travel mode and he replaced the glass
I don't want to stress the glass so the rest of the trip I just parked and didn't use the system. I have an appointment at BCS in April, but just wondering if you have heard of this happening?
I am very particular about all of my equipment, and want everything working as it should. I know something is not right, but I don't know what.
Any suggestions or advice is greatly welcomed.
Thanks.