BAC Forum
Supporting the RV Lifestyle
Show the most recent posts.
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
News:
Home
Help
Gallery
Login
Register
BAC Forum
»
General Boards
»
Technical Support
»
Changing out City water connection
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Changing out City water connection (Read 2211 times)
Jason Worman
Guest
Changing out City water connection
«
on:
February 11, 2021, 06:42:05 PM »
Hi All
Got up this morning and noticed puddle on the ground outside by city water connection. Went back inside and crawled under the sink and base of interior wall was damp. Peeled back fabric around connection on wall and it is damp. Any tricks to changing out the connection? Has four screws on outside connecting to the exterior wall. Thank you in advance.
Jason Worman
Logged
Frank Bergamo
BAC Member
Posts: 275
Thanked: 72 times
Re: Changing out City water connection
«
Reply #1 on:
February 11, 2021, 07:15:51 PM »
Jason,
it is a relatively easy process, pull the 4 screws then wiggle out of opening so you can access water connection on back of fill valve. Remove connection and install new one in reverse order. This is the valve,
https://www.wholesalemarine.com/shurflo-pressure-regulating-fresh-water-fill-wall-mount.html?gclid=EAIaIQobChMI6sn4oMXi7gIVwxatBh0F1g3cEAQYASABEgKuAvD_BwE
.
Hope this helps.
Logged
Frank & Paulette Bergamo
2019- : 2007 Marquis Topaz IV C-15 600 HP Allison 4000
2014-2019: 2002 Marquis Emerald C-12 505 HP Allison 4000
2004-2014: 1986 Executive Diplomat 3208 250 HP Allison MT-643
Grand Junction, CO.
Jason Worman
Guest
Re: Changing out City water connection
«
Reply #2 on:
February 11, 2021, 07:33:47 PM »
Frank,
Thank you for the part information. Surprised my has failed only about 2 years old
Jason
Logged
Frank Bergamo
BAC Member
Posts: 275
Thanked: 72 times
Re: Changing out City water connection
«
Reply #3 on:
February 12, 2021, 12:23:20 AM »
Jason,
depending where it is leaking, there are screws on the back of valve that you can tighten and sometimes stop the leak. If it is leaking around the hose connection swivel, then it will need to be replaced. Hope this helps.
Logged
Frank & Paulette Bergamo
2019- : 2007 Marquis Topaz IV C-15 600 HP Allison 4000
2014-2019: 2002 Marquis Emerald C-12 505 HP Allison 4000
2004-2014: 1986 Executive Diplomat 3208 250 HP Allison MT-643
Grand Junction, CO.
Jason Worman
Guest
Re: Changing out City water connection
«
Reply #4 on:
February 12, 2021, 03:04:39 AM »
Frank
I will give it a try. Thank you
Jason
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
BAC Forum
»
General Boards
»
Technical Support
»
Changing out City water connection