General Boards > Technical Support
Big slide doesn't extend, leveling system inop.
Zeb Severson:
The settings for the generator will be controlled by the inverter controller. I have the original Xantrex and the controller is RC7 GS (manual in coach assist), that is the manual that will guide you through the auto start config versus the manual for the inverter.
One of the reasons why I shared the info about the batteries is due to the inverter/charger being over 20 years old if yours is original. For my setup I have a concern that the charger isn't charging as it should either in volts or amps. All other indications of the inverter seem like its working fine. But... by tracking the condition of the batteries you can have a better sense of where the root of the issue is.
Good luck with everything.
Eric Maclean Co-Admin:
Nicholas
If both the chassis power and gen set power are not present check the 250 amp chassis main ANL fuse at the power distribution/isolator board you will find the schematic on page 43 of the 2003 patriot wiring diagrams found in coach assist.
Eric
Nicholas Soldevere:
--- Quote from: Eric Maclean Co-Admin on November 24, 2025, 12:43:21 AM ---Nicholas
If both the chassis power and gen set power are not present check the 250 amp chassis main ANL fuse at the power distribution/isolator board you will find the schematic on page 43 of the 2003 patriot wiring diagrams found in coach assist.
Eric
--- End quote ---
Viola Eric!! Got to digging around in there yesterday after finding no 12v up at the chassis power center. I went back there and found those fuses on the ceiling and sure enough nothing getting through that 250A chassis fuse. Took the fuse out and hooked it up with a battery jumper and the thing powered up and started. Fuse is on order, should be here today.
I suspect when the ground wire to the pump solenoid let go, it took out that fuse too, which is interesting because that pump has its own fuse. Ill be checking everything today, hopefully leveling system and big slide extends and the genset starts. Ill report back.
Can anyone help me with "log in" issues? I can get in here on this forum, but not the BAC website and not the schematics. A bit problematic when trying to troubleshoot.
EDIT: Thanks anyway, I have today successfully gotten in there to the drawings!! I noticed the sign in calls for email address vs screen name.
Steve Huber:
You need a separate PW and user name for the BAC club website since they are on separate servers. Your Forum PW and user name will not work unless you establish them on the BAC club web site
https://www.beaveramb.org/
Steve
Eric Maclean Co-Admin:
Nicholas
Glad to hear you got it fixed.
Eric
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version