Help......
We have a 2002 Contessa with three slides. This last week as we were trying to set up in Charlotte, N.C., neither the hydraulic jacks (the type of jack that levels the coach against the frame) nor the two front slides would operate. We had a tech look at things and he could not figure anything out, even after talking with Ken Carpenter in Oregon. We would try and extend the slide outs, the jack pad would go out, and when we would try and use the auto setting on the hydraulic jacks, we would let it go thru the motion of sensing what was low and then you push the auto button, and all it would do is flash and then go thru the process again of evaluating what was low or high. To summarize, we put blocks under the rear wheels to try and get level, and we installed switches to operate the slides from outside of the coach. I think we have a loose wire or a short some where, but where to start?
Any suggestions would be appreciated. There are not too many people that know how to work on the Beaver Coach in the south.
Thanks,
Jerry