Hi Guys,
Ever drive down the interstate and some guy in a big motorhome has his turn signals on but doesn't seem like he intends to change lanes. You finally decide to take a chance and pass him and hope for the best. So you pull in front of him and cycle your right and left turn signals repeatedly to advise him of his absent-mindedness.
Well as annoying as that is, I am guilty of such a crime because I can't hear the flasher and my steering wheel obscures the lighted turn arrow indicators.
Today I took action and added tone beepers purchased from Radio Shack (#273-0059) for $3.99 each to my turn signal indicator circuit. It was a pretty staight forward installation and took about a half hour. Remove the dash top access cover. Cut some ty-wraps to reveal the red and black wires going to the right and left arrow indicators. Strip back 1/4" of insulation and wrap the beeper wires around and solder. Red to red and Black to black. Tape up the connection and ty-wrap the harness as original. Butt splices will work if you don't want to solder the connections.
The beepers are 75db and sound great with the dash cover back on. You can fine tune the volumn with tape over the hole, however I found them ok right out of the package. Enclosed are some pictures for reference.
Regards, Fred