General Boards > Technical Support

Slides

(1/3) > >>

Steven Harper:
Our Main slide will not come in or out... It was working fine... checked fuses o.k. things are fine. Book on our 2008 Beaver Contessa says there is a curb side Slide Room Module located beneath the rear curb side cabinet... where is that cabinet located? We can't find that module... We have a 42 foot beaver contessa Rome

Steven Harper:
We have a 2008 Beaver Contessa.  Been parked at camping site for four days.  Slides working fine.  On our way home today our awning on the drivers side (Big slide) was flapping in the wind.  It was really really windy....  We stopped and extended our big slide so the awning would retract.  We did it once and awning not in all the way so we did it again.  This time the slide came in all but about 10 inches.  Switch quit working.  We were going to attempt to bring it in manually but our generator slide would not come out.  In the manual it says there is a slide room module located beneath the rear curbside cabinet.  It has a fuse and a auto-reset circuit breaker.  Where is the cabinet.  I can't find anything.  We finally got our coach home.  Slide is still out.  I plugged into fifty amp and the two bedrooms slides come out but the two front slides do not and the generator slide still does not work.   Can somebody help me please.  Has anybody else had problems with their awning coming out when it is windy while driving??

Thank you for your help.

Karen
712555

Steven Harper:
Does anyone know where the circuit breaker is for the two front slides?????  I think this might be my problem for the slides not coming in and out.  Thnks.


Karen
2008 Beaver Contessa
712555

Mike Humble:
We have had no problems with our 2008 Contessa.  The only thing I can find is a fuse labeled slide in the bath fuse closet.  Behind the black cover, not in the circuit breaker panel. It is 15 amp.  We have heard of the awning coming out, but have not had it happen to us.  Good luck.
Mike Humble

Gil_Johnson:
It sounds like your hydraulic pump is not working.  That's the fuse, breaker, or relay you should be looking for.

Navigation

[0] Message Index

[#] Next page