General Boards > Technical Support

SANICON FUSE

(1/1)

Ron Travers:
Hello,

I am new to the forum, but have heard from my fellow Beaver owners what a great place this is to get help, so here we go. I have an 07 Thunder that the sanicon system has stopped working. I am sure it is a fuse, but I cannot find it. I have looked both in the rear closet panel and in the outside compartment panel up front. I have the wiring diagrams for the coach, and can find a sanicon fuse on the diagram, but it does not tell me where it is. Any help would be appreciated.

Ron and Kris Travers
07 Thunder

George Harwell:

First things first, have you verifyed if 12 volts is available to the unit. Next insure the batterys are reading approximately 13.5 volts. To test the unit disconnect the unit wiring connector from the coach wiring, determine the correct (posotive & negative) pins and connect a 12 volt battery. If the motor runs continue the process of emptying the tank. This should get you by until you find the source of the problem. Good luck.

Navigation

[0] Message Index