Stan, Steve put my wiring diagram book in the Coach Assist section a month or so ago. Scroll down past brochures and manuals and such to Wiring Diagrams and then to the Monterey ones, and the 2006. That should be almost the same as yours. I’m not nuts about the Dropbox configuration of it, but you’ll want to scroll down to around page 12 of the book, “Keyless Entry Wiring”. It doesn’t give wire colors, unfortunately, but if your white wires have numbers and “descriptions” stamped on them you may be able to go by that. By the way you describe the “K” devices as “breakers”, but they are actually relays.
I don’t know if this link will take you directly to the book.
https://www.dropbox.com/s/g1bfb25hx6b1oxd/Total%20Document.pdf?dl=0A legend for the electrical bay is in the Coach Assist, listed just below the wiring diagram book.
The wire from circuit breaker 03 (CB03) and one from relay K20’s port 87 both connect to relay K21 at port 86.
It shows a short wire between K21’s ports 86 and 87.
The wire from K21’s port 87a goes to ground.
It’s port 85 wire ultimately goes (via wire #619) to the green connector at the Keyless Entry receiver under the dash access panel in front of the steering wheel (hopefully).
It’s port 30 should go (via wire #98) to the far right vertical buss in the bay, TB2, and connect at post 6 (“All Lock”). Hopefully a blue wire goes from there to the bay doors, and a #98 wire continues from post 6 to the entry door actuator.
Joel