Author Topic: 2003 Beaver Monterey Newport - front leveling jack  (Read 9210 times)

Ted Stouch

  • BAC Member
  • *
  • Posts: 3
  • 717 979-1570
2003 Beaver Monterey Newport - front leveling jack
« on: January 03, 2021, 10:23:13 PM »
When we park we usually put a board under the front jack, especially if we are in gravel, to provide support.  The problem I have is getting the board lined up properly with the front jack.  Is there an easier way to do this? 
😊 Ted
2003 Monterey Newport

Carl Boger

  • BAC Member
  • *
  • Posts: 545
  • Thanked: 167 times
Re: 2003 Beaver Monterey Newport - front leveling jack
« Reply #1 on: January 04, 2021, 12:03:49 AM »
I use a short piece of 6X6 with  a strap on it.  I can then take the awning pull/hook and position the block where it is needed.  I can lower the jack just enough to center the 6x6 then level.  Hope this helps.
Carl
2021 Renegade Verona 36VSB
350 HP  L9 Cummins 1150 Ft Lb Torque
98 Beaver Patriot Savannah
330 hp Cat 3126
The following users thanked this post: Ted Stouch

Neal E Weinmann

  • Guest
Re: 2003 Beaver Monterey Newport - front leveling jack
« Reply #2 on: January 04, 2021, 01:58:51 AM »
Similar solution done for my previous Beaver, but it doesn’t store as well as a strap... I used a small eyebolt in a two-ply treated 8”x8” square cut from a 2x8 screwed together with several 2 1/2” deck screws, each ply 90 degrees to the other. I felt as though the eyebolt allowed for more maneuverability than engaging a strap with the rod. Made a set of 3 from one treated 2x8 bought at a home center.
« Last Edit: January 05, 2021, 06:16:26 AM by Neal E Weinmann »