42
« Last post by Eric Wallace on April 23, 2024, 05:56:13 PM »
As I have continued my project of almost complete replacement of my Monterey brake system I have run into a puzzling situation.
I've tackled the front components first, calipers, pads, booster pump, master cylinder.
The front lines have been relatively easy to trace out, hard to get to, but an understandable path from master cylinder to ABS valve
and on to left and right front wheels. I just started digging into the rear system and have found a situation I am not understanding.
A brake line diagram would be such a help, but I can find nothing like what I am looking for. I made a guess that one long line would
go from the front of the coach and tee into two directions going to each back wheel. What I have found is two long lines going to the
back, one on each side of the coach. At the end of each long line is a tee with one branch easily seen and accessed going to each wheel.
The other branch of the tee on each side goes up toward the floorboard and quickly out of sight. I can't understand where they would be going.
Have any of you who have done replacing of your lines found this situation?
Also, what seems odd is that all the up front steel lines are 1/4", while the two long lines going to the back are 3/16".
Does that make technical sense?
Thanks for any ideas.
Eric