BAC Forum

General Boards => Technical Support => Topic started by: Jason Worman on October 09, 2018, 10:00:17 PM

Title: Command Center Fixes?
Post by: Jason Worman on October 09, 2018, 10:00:17 PM

I feel bad with so many questions. So I have replaced all the house batteries, they all tested at anywhere between 12. And 12.9 volts. Inverer/charger tested as putting out 13 volts and working properly. When I turn on the command center it shows battery at 10.5 volts and needing to be charged, also it shows a draw from Leg A (Normal), Leg B (Normal) and also draw from VDC volts of 6-9 amps. This is while plugged into 50 amp shore power. Any way to reboot the command center or fix?

Jason

Title: Re: Command Center Fixes?
Post by: Steve Huber Co-Admin on October 09, 2018, 11:20:38 PM

Jason,
Suggest you use a volt meter and check the actual voltage at the batteries prior to and when the C Center is showing the low volatge. Could be a bad connection to the C Center. The DC draw when on shore power could be your reefer. As Gerald noted in an earlier post, it requires 12v to run regardless of power source.
Steve