BAC Forum
General Boards => Technical Support => Topic started by: Rick Penick on September 26, 2020, 12:29:08 AM
-
So the latest is i want to run the codes on my 3126 read manual and says cruise off/ key on/ and hold down set/resume switch. Did that 5 times nothing . Searched around on website tried putting in my problem says nothing search check i could be a week searching. Any ideas help would be appreciated.
Thanks
Rick
-
Rick, the information you are asking about is located in the Ask Dave section on this forum.
Dave Atherton Retired Cat Mechanic
-
Dave thanks for the one reply. I went to tech support on forums i see no ask dave. i found over 100 some questions two of which addressed some problems but none address why i am not able to get the codes by following the operators manual for the CAT engine.
Rick
-
Rick
Go to members only section and the top topic is ask Dave
Eric