BAC Forum

General Boards => Technical Support => Topic started by: Larry Waterman on April 26, 2012, 12:10:16 AM

Title: Propane Detector Fuse
Post by: Larry Waterman on April 26, 2012, 12:10:16 AM

We have a 2008 Beaver Contessa that has a propane detector in the kitchen near the floor under the stove and a carbon monoxide detector in the bedroom on the ceiling.

There is no power to either detector and I haven't been able to track down the location of the fuse.

Any thoughts??

Title: Re: Propane Detector Fuse
Post by: Larry Waterman on May 02, 2012, 09:01:37 PM

I had not looked for the fuse since I posted my question.

I resumed my search this morning and found the fuse in the bay/door to the rear of the batteries where the cut off switches are for the chassis and house batteries.

It is the fourth 15 amp fuse up from the bottom on the right side of the panel.

I shut off the external power and then shut off the red chassis switch, which cut all power to the panel.