BAC Forum

General Boards => Technical Support => Topic started by: Roy Lewis on July 07, 2016, 09:21:22 PM

Title: Gen exhaust
Post by: Roy Lewis on July 07, 2016, 09:21:22 PM

Looking over outside of our 2002 Marquis Tourmaline I noticed the generator exhaust pipe was down a bit at the termination of pipe, 2 clamps screwed into belly the screws are gone. Can anyone tell me how long a screw they went into belly with?

Title: Re: Gen exhaust
Post by: Edward Buker on July 07, 2016, 11:39:11 PM

You should be able to gauge the depth of the current holes with a piece of wire to obtain a screw length.

Later Ed

Title: Re: Gen exhaust
Post by: Lee Welbanks on July 07, 2016, 11:57:35 PM

Roy, Two screws into the belly: belly of ?
My exhaust pipe support is mounted to the genie steel frame.

Title: Re: Gen exhaust
Post by: William Jordan on July 08, 2016, 01:03:52 AM

Mine too . The gen is only connected to the frame of the generator support frame, as it moves with that frame .  You aren't referencing the Auga hot exhaust which is mounted to the " belly" are you  ? 

Title: Re: Gen exhaust
Post by: Roy Lewis on July 08, 2016, 04:05:43 AM

I have 2 pipes terminating at same spot, 1 square Aqua hot and 1 round pipe. Our coach has side generator, 2002 Marquis Tourmaline.