BAC Forum

General Boards => Technical Support => Topic started by: Adam Hicklin on May 26, 2020, 11:23:40 PM

Title: Racor retrofit kit
Post by: Adam Hicklin on May 26, 2020, 11:23:40 PM

I’m swapping out old rancor primary filter with the new retrofit kit. Seems pretty straight forward but the new wiring harness has one lead to the water probe and the other is supposed to onnect to the “engine ground harness”. Current filter assembly only has one lead to the water probe, that I can see.  What do I do with the second wire? 
Thanks for the help

Title: Re: Racor retrofit kit
Post by: Bill Lampkin on May 26, 2020, 11:32:11 PM

I would thnk any good ground location close by would work. YOu might even find a mating connector at NAPA or other parts store.