BAC Forum
General Boards => General Discussion => Topic started by: Clint Davis on November 11, 2025, 05:01:09 PM
-
Hey Folks,
I recently purchased a 2008 Contessa. I want to remove the old Winegard satellite that was factory installed. In it's place, I plan to mount a 12x12x4 junction box. The junction box is adding solar panels and cabling later. On top of the junction box, I'll mount a Parsec Husky 5G/WiFi antenna to stream Directv rather than use a dish. I'd like to run the antenna wires into the junction box, down through the roof, and over into the cabinet next to the entry door. As you can see in the picture, the factory ran the wires across the roof and through a gland above that cabinet. A bit messy in my opinion.
Have any folks here run wires through the roof/ceiling in their Beaver? Just wondering how much trouble I might run into with this plan.
(https://i.postimg.cc/JGWtQ1K4/IMG-6309.jpg) (https://postimg.cc/JGWtQ1K4)