BAC Forum

General Boards => Technical Support => Topic started by: Bruce Benson on October 02, 2012, 08:23:31 AM

Title: Torque value for hub caps
Post by: Bruce Benson on October 02, 2012, 08:23:31 AM

Does anyone know the torque value for the axle hub cap bolts?  These are the caps with the rubber stopper, which is inserted into a circular sight glass, on the ends of the steer and tag axles.  The Dana service sheet says to tighten them to the appropriate torque but fails to mention what that torque is.  

Title: Re: Torque value for hub caps
Post by: Bruce Benson on October 02, 2012, 07:10:19 PM

It is stamped on the hub.  Woops!

12-16 ft lbs

Now searching for the drive axle values.