BAC Forum
General Boards => Technical Support => Topic started by: Mike.Way on December 28, 2012, 02:28:06 PM
-
In another post I said I got my AquaHot running but not completely.
I replaced the pressure cap and checked the fuses and it lit right up. Afte a couple of hours though it wasn't running. If I pulled and pushed the second from the left fuse up it was good for a few hours again. On again, etc.
The fuse is good, thoroughly checked. Acts like a fuel issues?? Like it burns until the fuel reservoir is empty. Then kicks off and I can restart after it refills? Some type of restricted flow?
Any ideas?
Mike
-
Contact Orman Claxton. See yesterday's posts by Orman.
"Feel free to call me @ 206 660 9893
Thanks
Orman"
"I am a Beaver owner and Forum member
I am also an Aqua-Hot Factory trained Authorized Service center
Please feel free to call me @ 206 660 9893, EMail Ocroadhouse@yahoo.com
Maybe we can get you going on the telephone"
Orman is a great guy who has helped many BAC members over the phone and at rallies.
Larry