In the Beaver I had noticed that some of the Burl inlays were starting to lift around the edges on the cabinet doors. So how to glue and clamp these so wood block will not stick to the door. Used a teflon sheet from the kitchen section Walmart, oak wood blocks and $5.00 cheapo clamps from Harbor Freight. Used a artists small paint brush to apply the Gorilla glue in under the edges, wipe off excess with wet paper towel and clamp her down. Works great cause the teflon will not stick in the glue. the Gorilla glue drys clear so if there is a little squeeze out you can not notice it. Good as new, let dry for a few hours and on to the next one. After a close inspection almost all the doors inlays have lifted some.