Howdy to all,
Hydro hot has quit heating our hot water.
2006 Monterey, we are on 50amp shore power.
went to the electronic control panel (ecp) and the 'low tank level cutoff' light was on (red). Checked level and was very low in the tank, nothing in the little overflow tank. Bought some antifreeze, Camco 100degree premixed, took right at a gallon to top the tank off.
Turned on the switch inside the unit near the sink and waited about on hour.....no hot water...went back to the ecp and the electric heating element status and the heating status led's were green. The low tank level cutoff led was still red.
Tried resetting the unit at the 'low voltage reset' per others advice, both with the switch turned on and off (was not sure which way would cause the unit to reset). this did not eliminate the red led. After some research thought I had not let the system run long enough so I switched it back on, this time for approx. 1 1/2 to 2hrs (hope I have not compounded the problem), still no hot water. Not quite sure what the problem could be....low solution..filled it up..turned on switch to reheat solution...
??
Any suggestions or advice would be very appreciated before I have to call out a technician, especially if it is a fairly easy fix...fingers x'ed.
Also I have been unable to locate the electrical breaker for the hydro hot. It is not marked at the main panel in the bathroom and I am not aware of another panel in the MH.
If any other information is needed for a fix please let me know. Momma wants some "hot water"....lol
Thanks to any and all who will take the time to respond to my dilemma.
JZ