Author Topic: No power to Valid Power Gear panel  (Read 1458 times)

Albert Balika

  • BAC Member
  • *
  • Posts: 72
  • Thanked: 9 times
No power to Valid Power Gear panel
« on: October 06, 2021, 07:11:05 PM »
I started the engine today and have no power to the leveling panel on my 2007 Contessa Bayshore 42ft. I checked all fuses in bay on driver side. The only fuse that was not getting power was F-17 which does not show on the fuse and relay schematic. It is a 5amp fuse which looked good, but I replaced it with a new one and still no power. I looked at the relay schematic as well and don't see any relay that is leveling related. Since the ignition has to be on to activate the leveling system, could it be an ignition related relay? All of my relays in this bay are identical (Tyco 01432785-1). Do any of these relays relate to the leveling system? Any help would be appreciated.
07 Contessa 42'
C9

Bryan Beamon

  • BAC Member
  • *
  • Posts: 366
  • Thanked: 133 times
Re: No power to Valid Power Gear panel
« Reply #1 on: October 07, 2021, 01:50:26 AM »
Albert, try fuse f43 in your service panel below the drivers area. The fuse is labeled ( vci-10rear air batt+ ) and is a 10 amp fuse. When I called Valid in Salmon Arm British Columbia they gave me that location for the control panel power. Valid tech support # 250-804-1247.
C & Bryan Beamon
2006  to present
2007 Contessa 42ft Cat C-9 400hp
1996 to 2006 97 Beaver Patriot Camden