General Boards > General Discussion

Turn and hazard lights not working

<< < (2/5) > >>

Steve Huber Co-Admin:
Jose,
To get the individual lights to come on, where did you supply the 12v?
Steve

Jose Rita:
Steve, to terminals 2,3, 13 and 14

Jose Rita:
Steve, solenoid relay has 12v battery power

Steve Huber Co-Admin:
That seems to confirm Eric's input that the turn signal switch is either not getting power or is faulty itself. Check for voltage at the turn signal and hazard switch.
Steve

Eric Maclean:
Jose
remove the flasher and place a jumper wire in it's place then turn on the signal either direction and check to see if the corresponding turn signal lights up.

Navigation

[0] Message Index

[#] Next page

[*] Previous page