General Boards > General Discussion
generator belt replacement
Michael DeFalco:
ah ok understood. well today i felt courages i began the belt replacement. WOW what a treat! i finally removed the top only to find out that was the easy part!! the front shroud was a bugger. that was my fun for today. but i am pleased to find my gen problem was the belt ! i am planning on returning tomorrow to complete. thank you Fred for the information on this issue, but you forgot to tell me that not only do i need a bag full of tools, borrowing your magic wand would have been much better!
thanks for the help .
Dan Johnson:
Michael
I have to do the belt job on my 2002 marquis emerald. Could you post some pictures of getting to the belt?
Dan
Fred Brooks:
Here is a picture of the cooling system for an Onan 10K
Michael DeFalco:
Fred was able to complete the belt replacement today, thanks again for the info you provided me it gave me that little bit of confidence i need to tackle that job. boy returning a couple of the casing bolts was a bugger. but its back on line thanks
Michael DeFalco:
hey Dan , i did not photo anything. but what i found out is doing what
Fred suggested extend the slide then climb inside. remove the top remove the right side panel which folds around the gen. that panel is part of the front and the complete side. if you have an open end wench with a box ratchet at the end you will be happy.
once that panel is removed you will find the shroud remove that then you can remove the fan wheel , then remove the mounting plate , now you will have found the belt !! inside that compartment is tight but ,i am 6ft 5 I was able to move around a little
the job can be done just some of the bolts are a bugger to remove and replace . good luck oh the panel bolts are a #10 metric
Navigation
[0] Message Index
[*] Previous page
Go to full version