General Boards > Redecorating and Updating your Motorhome

Valences: ideas wanted

<< < (5/7) > >>

Keith Oliver:
Got the job done today.  The A pillars are out, to get covered, will be back in tomorrow.  Then I will post some pictures.  The original valences are almost deep enough, but about 1/2 of them had to be relocated out from the wall to give adequate clearance.  Now that the legs and bottoms of the valences are off, the original wall covering is really looking sad, so I think there will need to be some improvement to those before the new valences go on.  

The new A pillars are made of plastic, bent at 90 degrees and cut to fit around the blind rolls at the top and close to the dash at the bottom.  Once covered with new fabric, they should disappear.  Wait for tomorrow's pictures.

Keith Oliver:
Pictures: Sorry, I have forgotten how to shrink my pictures to less than 1 MB, so can't post any until I get that sorted out.

Richard And Babs Ames:
Keith, you can set your camera to take a picture that has an e mailable or up loadable file size. I went from a non uploadable file size to one that uploads in a couple seconds by changing my camera settings.

Steve Huber:
Or, take picture as normal. Load into PC. Select picture. Click on Picture on toolbar. Select Resize. Options are document, web or emaal, resulting in smaller picture in that order. Document usually works OK for Forum. Save work and they are ready to load on forum page. You may want to make copys first as this permanently resizes them.
Steve

Steve Huber:
Oops,  "Select Compress Picture", not "Resize"
Steve

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version