General Boards > Sources for Suppliers, Parts and Maintenance Materials

Starlight 1000B LED motion light

<< < (2/2)

Bob Stone:
Initially I could not get the light to function either manually or via the heat sensor. Upon checking the LED bulb I found it to be non-functional. With an incandescent bulb I was getting a red flashing LED at the fixture indicating a voltage of less than 11.5 volts. Once I replaced the incandescent bulb with a new Led  the fixture now works as it's supposed to however the switch must be on and therefore have the three steps lights on continuously. The step bulbs are very tiny and likely draw very little power. I considered rewiring them to the handlebar light switch but on pulling the mass of wires from behind those four switches at the door it looked like a daunting task.

For now the light goes on when it's in manual mode and automatically when it senses a warm body within it's range provided the switch is on and the fixture is in the 'auto' mode.

Better than what was there but a ways to go before it's perfect.

Navigation

[0] Message Index

[*] Previous page