General Boards > Sources for Suppliers, Parts and Maintenance Materials

Chassis lubrication

(1/2) > >>

Doug Allman:
I do not know if it is just me or I found something several of us have been missing.

The steering column has numerous grease zerks that are not the easiest to find or access. I made some assumptions from our 1991 Contessa that I found yesterday were not totally correct on the Marquis.

The column has two u-joints that have zerks, for both the Contessa and our Marquis. Both of them in the Contessa were up under the column cover under the steering wheel. The Marquis has one under the cover and one below the floor. The marquis also has one on the shaft between the two joints where it slides.  On the Marquis there is another zerk on the back side of the steering gear box that is covered with a plastic cap.

I definitely noticed when I greased the Contessa it steered a little better. I think they improved the steering mechanism in the Marquis as I have not noted that much difference. However whether you do the chassis lubrication or you have someone do it for you you it is something that may be of help to get all the zerks greased. I did not notice this info in any brochure I got with the coach. Found it when I was doing dash a/c repairs.

Hope this info helps someone.

Edward Buker:
Doug,

You may be beyond the point where you could take a couple of location photos of the Marquis steering column zerk fitting locations but maybe not.... It could to help to have this location info in a photo even if you have the chassis lubed by someone else.

Later Ed

Bill Borden:
Doug,

Your post prompted me to check the steering column.  Question did you find the joint under the rubber boot? 

I can definitely feel a u-joint under the boot.  Is that the one you are referring to.


Bill Sprague:
On our '04 Monterey, I think I remember finding two behind the plastic boot.  Both were greasy after 10 years.  I greased one but could never find a grease gun that would attach to the other.   

Doug Allman:
Inside the coach, I found a u joint under the hard plastic boot that covers the steering column in front of the drivers chair. On our 1991 Contessa there were 2 joints in this area.

Outside the coach, in the chassis area on the Marquis there is another u joint about 6 inches below the floor and just above that u joint is a collar that also has a zerk. I take it that is for a sliding shaft.
These two zerks are just above the steering box. The steering box also has a zerk on the back side of the box covered with a plastic cap that fits right over the zerk itself.

To grease the u joint zerk above the steering box I had to turn the steering wheel far to the right to get grease gun tip onto.

Navigation

[0] Message Index

[#] Next page

Go to full version