General Boards > Technical Support

toilet seal

(1/2) > >>

Roger Baldwin:
Our toilet is no longer holding water.  Is it possible to change the rubber seal ourselves or is this a problem left to a professional?

Gerald Farris:
If you have the standard Sealand gravity flush toilet, it is a fairly easy repair by the average handyman. I have replaced the seal on my 2000 and my '93 before that. The new seal will come with easy to follow instructions.

Gerald

Richard And Babs Ames:
Before replacing the seal clean the old one. We open and wipe arround the bottom with TP and an old toothbrush. It has worked for us for the 10 years we have owned our 97 Patriot with a Sealand Toilet and the 6 years we had the Baronett.

Be careful not to drop the tooth brush. We tape a string to it with duck tape because I am clumsey and we just throw the brush away. Usually TP wipe when cleaning is enough. Only reason to replace is if it is torn.

Gerald Farris:
I agree with Richard on cleaning the seal. We clean the seal approx. monthly, however as a fulltimer I have only been able to get 7-8 years on the seal before the teflon coating on the rubber seal wears to the extent that it will no longer hold water in the bowl. So if you have not been cleaning it, clean the seal completely and carefully first, but replacement may ultimately be needed.

Gerald

Richard And Babs Ames:
I agree with Gerald that as afull timer he is getting max live out of his seal. We as part timers can expect a longer life span. The cleaning and not being harsh about it is the most important consideration.

Navigation

[0] Message Index

[#] Next page