Author Topic: Where to get parts for heater control  (Read 3233 times)

Mark Beavin

  • Guest
Where to get parts for heater control
« on: January 03, 2019, 01:17:57 PM »
  While repairing my wipers squirters I noticed a cable that was not hooked to the heater control valve. It is all rusted and needs to be replaced. I see it is connected to the heater/ac temp control on the dash. Anyone have a part number or break down of parts on this?

Mike Shumack

  • Guest
Re: Where to get parts for heater control
« Reply #1 on: January 03, 2019, 02:45:42 PM »
Do you have a heater valve similar to this one?
You can get universal control cable at NAPA https://www.napaonline.com/en/p/TWRMEI2541
Also a call to "Beaver Coach Sales" is always a good starting point.

Mark Beavin

  • Guest
Re: Where to get parts for heater control
« Reply #2 on: January 03, 2019, 05:03:44 PM »
The control valve is ok. I lubed up the cable and it is free. The dash control will push the cable in for cold but does nothing when I turn the knob to hot. Does the water pressure push the cable back to the hot position? or is there a return spring missing?

Mike Shumack

  • Guest
Re: Where to get parts for heater control
« Reply #3 on: January 03, 2019, 06:44:53 PM »
If I recall, you have three knobs for AC/Heat. No sliding lever.

One knob is the fan speed, one knob is Temperature Control, the other knob is Function selector (Defrost, AC ducts, Vent, etc).

The fan is electrical switch, the Temp Control has the cable attached, and the Function control is vacuum operated (opens/closes blend door and vent/defrost doors).

Does this describe your setup?
« Last Edit: January 03, 2019, 06:55:22 PM by Mike Shumack »

Mark Beavin

  • Guest
Re: Where to get parts for heater control
« Reply #4 on: January 03, 2019, 08:13:49 PM »
Yes is the cable temp control. I took the control apart and saw nothing wrong with it. Put it together and it works fine.....Go Figure......