Recent Posts

Pages: 1 ... 8 9 [10]
91
Technical Support / Re: Engine Shutdown While Driving
« Last post by Fred Cook on October 03, 2026, 10:55:55 PM »
At the coach, AI was clueless on the relay. I now have it. It appears to be a hard to find part? Thanks!

Nope, you can get that relay on Amazon all day long. G8P-1A4P-12VDC 30A 250VAC Fully-Sealed PCB Relay for PC Board. Pretty sure this is what you need for your circuit board in your rear run box.
92
Technical Support / Re: 2001 Beaver Marquis. Transmission selector not working
« Last post by Vernon Boen on October 03, 2026, 10:44:38 PM »
Hello Everyone. Just wanted to let you all know I got the problem resolved. I have lost power 12 volt battery voltage to the vim somewhere between the vim and battery. I looked every where I could think of for the issue and finally just chose to run a new wire from the constant 12 volt side of the solenoid in the electrical bay and that totally fixed my issue. Thanks for any input given and hopefully this helps someone else in the future.
93
Technical Support / Re: Engine Shutdown While Driving
« Last post by Bill Heffernan on October 03, 2026, 04:57:51 PM »
At the coach, AI was clueless on the relay. I now have it. It appears to be a hard to find part? Thanks!
94
Technical Support / Re: Engine Shutdown While Driving
« Last post by Bill Heffernan on October 03, 2026, 02:09:52 AM »
More - rough start to yesterday. It shutdown probably 15 times before it started and ran for 30 minutes without issue. We ran it to Freightliner in Olympia. They finally got to it this afternoon. They found that the volts were dropping to the ignition relay. They are messing around on the repair and likely can't touch it until next week sometime. I'm going to jumper it to get it out of there. I'm not at the coach currently. A search indicates that the relay is an AC Delco F1757. Can anyone confirm? Thanks
95
Technical Support / Re: Engine Shutdown While Driving
« Last post by Scott Shearer on October 02, 2026, 09:38:37 PM »
Dan,

The engine-shutdown issue discussed in this thread—unexpected shutdown and/or cranking without starting—is specific to 2006 and newer Monaco-built Patriot, Patriot Thunder, and Marquis coaches equipped with Intellitec circuit board-based front and rear run boxes.

Your coach uses engine run/start circuitry that differs significantly from the Intellitec system. However, it can experience similar run/start issues, including problems with the remote-start function.

Several BAC threads address these issues for your coach’s model and year and include recommendations for fixes and spare parts.

-Scott
96
Technical Support / Re: Engine Shutdown While Driving
« Last post by Allen Heath on October 02, 2026, 05:28:37 PM »
It's an '07 Patriot Thunder 45' Winchester III.  Probably close to the OP's coach.  C-13, build date 09/06
Full function Aladdin, Medallion cluster, etc

I just figured out how to add that to my signature.
97
Technical Support / Re: Engine Shutdown While Driving
« Last post by Dan Johnson on October 02, 2026, 02:01:54 PM »
Allen   What year of beaver do you have? Are the engine stopping issues the Monaco version or the beaver make version?
98
Technical Support / Re: Engine Shutdown While Driving
« Last post by Allen Heath on October 02, 2026, 03:26:52 AM »
I had the annoying loss of power and engine turning off for about a year and a half. Shops could not find the intermittent problem.  Then one time while I coasted to a stop on the road I immediately went to rear run box and all the LEDs were off.  I thumped the relays and the "weak" one came back to life and the RRB lit up like the Christmas tree it should be.  So, I had now identified that illusive relay, and as I was in Newfoundland at the time I picked up a common Bosch pigtail and relay and soldered it in parallel to that relay.  Worked for 3 months until I got back home and did a proper replacement solder job.  I would highly suspect the same relay Fred and I had experienced.  When the contacts break connection the ECM just thinks you turned the key off so the engine stops while all the gauges report a comm failure as they are still powered on but the ECM isn't talking to them. Sometimes a bump in the road would shake that relay enough to re-make contact or sometimes break contact.  Turning the key Off and back On would most of the time have the contacts close firm enough to work again for a while.
99
Technical Support / Re: Engine Shutdown While Driving
« Last post by Bill Heffernan on October 01, 2026, 02:49:00 PM »
Thanks Scott. We are moving again later today, I'll be watching for it.
100
Technical Support / Re: Engine Shutdown While Driving
« Last post by Scott Shearer on October 01, 2026, 10:01:00 AM »
Bill,

Seeing zero boost would be expected, the engine sensors have lost power because the 12-volt switched ignition power to the engine ECM has been lost (loss of engine comm).

Our 2006 PT does not have the Medallion Digital instrument panel or the Light Bar like your coach, but I am running the Silverleaf VMSpc. Both the Medallion Digital system and the Silverleaf receive their information from the same source, so it should be a reasonable comparison.

When our engine shutdown the speedometer, tachometer and transmission gear attained were all registering data. I could see the transmission shifting down until I selected neutral. I did see the oil pressure light turn red and the oil pressure gauge go to zero (a bit alarming).
 
Suggestion, when you go back on the road run with your Aladdin system engine/transmission data screen displayed. If all engine data goes to zeroes during a shutdown, you’ll know that the 12-volt switch ignition power has been lost, the Aladdin system requires it to display any engine data.

-Scott
Pages: 1 ... 8 9 [10]