BAC Forum
General Boards => Technical Support => Topic started by: Jason Worman on April 12, 2021, 08:46:38 PM
-
Hi all
Anybody have a recommendation of a good lubricant for the leveling Jack's and springs? The pistons look like they could use some lubrication.
Jason
-
Jason
In an of the information I've read HWH , RVA and others all recommend using WD40 to lube the jack rams .
Wild down any dust or dirt before spraying the rams with WD40 then spray the seal area and ram well and when done run the jacks up and down a few times before wild them down again to remove the rest of the WD40 so that dust and dirt don't collect on the rams.
Hope this helps
Eric