BAC Forum

General Boards => Technical Support => Topic started by: LaMonte Monnell on September 04, 2021, 01:25:44 AM

Title: Aqua hot issue, new one this time.
Post by: LaMonte Monnell on September 04, 2021, 01:25:44 AM

My Aqua hot in my 2001 contessa is having an issue after the water reaches temp, cycles thru shut down procedure and keeps cycling without turning off. Just started this recently as it’s working super otherwise.
I have to turn the switch off and then remove the hot feed to control panel outside to shut down.
I looked in my troubleshooting steps but don’t see this addressed anywhere.

Where would I begin to look?

Title: Re: Aqua hot issue, new one this time.
Post by: Keith Moffett Co-Admin on September 04, 2021, 07:34:50 AM

Believe I would ask Aqua Hot tech on this.

Title: Re: Aqua hot issue, new one this time.
Post by: Bryan Beamon on September 04, 2021, 03:49:19 PM

Lamonte, we had to replace our controller which was attached to the diesel burner to fix our unit based upon similar symptoms you are experiencing.

Title: Re: Aqua hot issue, new one this time.
Post by: Keith Moffett Co-Admin on September 07, 2021, 07:37:23 AM

Lamont,
In the Aqua hot manual is a description on how to test the controller.  It varies some with differing models I believe but requires pulling the smaller connector and jumping across a couple different pins.  Might eliminate the controller as part of the issue or confirm it.