BAC Forum
General Boards => Technical Support => Topic started by: Rick Penick on September 18, 2021, 12:38:07 AM
-
Replaced starter and will fire right up at genset but not from dash. Appreciate some help if anyone has dealt with this issue.
Thanks
Rick
-
Rick
Suspect you have a wiring issue. Check to be sure you connected all the wires that were removed.
Steve
-
Rick
There should be a wiring harness and plug close to the gen set that runs to the dash switch I'd check that plug for connection's
Eric
-
Thanks guys i will check that and try and trace wiring if that plug doesnt do it .
Rick