BAC Forum

General Boards => Technical Support => Topic started by: Richard Good on November 25, 2021, 03:24:48 AM

Title: Dim headlights
Post by: Richard Good on November 25, 2021, 03:24:48 AM

I performed the dim headlight test on my 98 Beaver, and yes they brightened up on installing a jumper per the video. I rushed off, purchased the 2 relays and some wire and started to make the modification per the video only to come to a screeching halt when I discovered 3 wires on the low beam terminal instead of 2. As it was beginning to get late I decided not to start the process and came back to see if anyone else had the same problem. I have seen no other mention of this so assume this issue has not come up before. If anyone out there has had the same situation, can you let me know the fix.

Title: Re: Dim headlights
Post by: Mike Shumack on November 25, 2021, 11:35:41 AM

Which terminal are you referring to that has three wires (a relay)? The headlight connector should have three.

This is the Headlight Mod. I have a pdf document with the whole process explained (but too big to attach here. If you want a copy e-mail me).
This is a snip from that document.
I hope this helps. Good luck.

Title: Re: Dim headlights
Post by: Steve Huber on November 25, 2021, 01:12:21 PM

There's also a step by step writeup with diagrams on Coach Assist.
Steve

Title: Re: Dim headlights
Post by: Richard Good on November 27, 2021, 04:50:42 AM

Job accomplished thanks for some phone clarification from Roy, and thanks for all the input from everyone else.