BAC Forum
General Boards => Technical Support => Topic started by: John Demartini on June 17, 2024, 01:52:27 PM
-
Hello fellow Beaver owners. My dash fan is operating only on high, I'm assuming the resistor is bad. I located the resistor under the front cover close to the steering box area. I unplugged the resistor and the fan operated the same, only on high. Does anyone know of a source for a replacement?
Thanks for any suggestions or advice offered.
-
John
The blower resistor is a Ford #D8BH-19A706-AB
Just ask you local parts store NAPA (etc) for a blower resistor for a 1980 Ford F100 with Air conditioning.
Or a Standard Motor Products # RU-439
While you at it check the plug for burnt connectors
Hope this helps
Eric
-
Thanks Eric. I’ll make sure to check connectors for fan, resistor and switch.
-
Hi Eric:
Just got around to pulling out the old resistor. PT# on old part was D32H-19A706-AB. Still a similar application but a different number Just an FYI.
Thanks...
-
Thanks John
The main number is the same just the prefix number is changed
Ford often did that on new production runs or tooling .
Did the new resistor cure your problem?