BAC Forum

General Boards => Technical Support => Topic started by: Jeff Lynn on May 13, 2025, 03:25:07 AM

Title: SID 33 Error Code Fan Clutch Output Device
Post by: Jeff Lynn on May 13, 2025, 03:25:07 AM
My 2006 Beaver Patriot Thunder with C-13 engine is throwing an error code when I climb hills. The code I pulled with SID 33 Fan Clutch Output Device. I have a side radiator with a hydraulic cooling fan. My motor doesn't come close to running hot so I'm not concerned about overheating, but I would like to solve this check engine issue.  Thanks for any guidance.
Title: Re: SID 33 Error Code Fan Clutch Output Device
Post by: Steve Huber on May 13, 2025, 02:05:49 PM
Jeff,
My guess is that the hydraulic fan clutch is not kicking the fan into high speed mode when hill climbing. More info may be in your C13 engine manual or a call/visit to a CAT shop may provide more info. You may also be able to check the fan operation by idling the engine. The fan should be running at low speed. Then block the radiator with a piece of cardboard, etc and as the engine temp increases the fan speed should increase.
All that said, it also may be that your fan is stuck in high speed mode. That would explain the lower temp readings climbing hills. But then it's not clear why it throws the code.
Steve
Title: Re: SID 33 Error Code Fan Clutch Output Device
Post by: Jeff Lynn on May 14, 2025, 01:14:09 PM
Steve,
  Thank you for taking time to respond.  I just learned that I had a hydraulic fan. That is a new concept to me. I am going to go coach next weekend an search for the wiring to the fan and the PTO. I'm sure I will end up taking my rig to a CAT shop.

Jeff
Title: Re: SID 33 Error Code Fan Clutch Output Device
Post by: Steve Huber on May 14, 2025, 06:40:46 PM
A search for "Hydraulic fan" here on the Forum will yield more info about the system.
Steve
Title: Re: SID 33 Error Code Fan Clutch Output Device
Post by: Frank Bergamo on May 15, 2025, 12:21:15 AM
I belief your coach has a Wax Valve controlling your cooling fan. No electronics involved, all hydraulic. It will be located inside the rear engine compartment, to the left, screwed into the radiator. It will have two smaller hydraulic lines connected to it. Search “Thermal Wax Valve” for info. As far as your error code, have no idea what that would be. Hope this helps!
Title: Re: SID 33 Error Code Fan Clutch Output Device
Post by: Jeff Lynn on May 16, 2025, 12:36:54 AM
Frank, thanks. I will look for the Wax Valve.
Title: Re: SID 33 Error Code Fan Clutch Output Device
Post by: Jeff Lynn on May 16, 2025, 04:03:15 AM
I just changed the hydraulic filter and reset the indicator button and now with less than 1 hour of engine run time the button is up again. What could be causing this pressure issue?  Could it be the Wax Valve
Title: Re: SID 33 Error Code Fan Clutch Output Device
Post by: Scott Shearer on May 16, 2025, 07:41:24 AM
Jeff,

Check out this post and see if it might be helpful.
https://beaveramb.org/forum/index.php/topic,8084.msg55965.html#msg55965

Also, search the forum for 'MP Filtri', you’ll find several posts related to hydraulic filter clog indicator tripping issues.

-Scott
Title: Re: SID 33 Error Code Fan Clutch Output Device
Post by: Jeff Lynn on May 16, 2025, 05:04:08 PM
Will do. Thanks Scott