BAC Forum

General Boards => Technical Support => Topic started by: John Demartini on September 26, 2025, 04:26:17 PM

Title: Drive Shaft U Joint bolt torque spec
Post by: John Demartini on September 26, 2025, 04:26:17 PM

Good Morning:

Recently had a short tow, needed to reconnect driveshaft at differential.  I snugged them up, but have not set the torque yet.  Does anyone have a spec on these, or if you can tell me where to find?

2000 Patriot
3126b
Allison Trans

Thank you...

Title: Re: Drive Shaft U Joint bolt torque spec
Post by: Eric Maclean Co-Admin on September 27, 2025, 12:51:49 PM

John
It depends on the size of the yoke bolts whether or not kit has "u" bolts , end caps or straps with bolts .

This link should help it covers drive shaft mounting ( at the bottom of the page)

https://spicerparts.com/resources/lube-torque-specs

Hope this helps
Eric