BAC Forum

General Boards => Technical Support => Topic started by: Jim Shaw on December 27, 2011, 04:40:25 PM

Title: Belt routing
Post by: Jim Shaw on December 27, 2011, 04:40:25 PM

The belt on my ISC 350 is cracking and I would like to change it before it brakes. It looks like I can do this by pulling up the floor in the closet for access, but it is difficult to see how it is routed with the rear radiator.  Is there a diagram available that I could look at. I have a 2003 Monterey with the Cummins 350 engine. Has anyone changed the belt this way rather than removing the radiator and CAC?

Thanks Jim

Title: Re: Belt routing
Post by: Bill Sprague on December 28, 2011, 03:56:09 PM

Jim,

I have the same engine but with a side radiator.  I should be able to take some pictures and email them to you.  My phone and email are in the BAC member directory.

Title: Re: Belt routing
Post by: Jim Shaw on December 28, 2011, 11:13:10 PM

Thanks Bill but I am going to remove the CAC and I should be able to see everything. If not I will call you.
Jim