BAC Forum
General Boards => Technical Support => Topic started by: Edward Buker on February 07, 2012, 12:41:28 AM
-
A half dozen of my cabinet doors had some edge lifting of the burl veneer. Anywhere from 1/2 inch in to several inches lifted, usually on one of the smaller veneer panel ends, as opposed to the longer dimension.
I just wanted to pass along that Gorilla makes a white water based wood glue. It is type 2 good for both indoor and outdoor applications. It is a bit more viscous than Titebond and therefor stays in place better and tends to not squeeze out as much excess glue while clamping (as long as you use what is about the right amount to wet the surfaces)The clamp time is 30 to 45 minutes and the excess cleans off well.
Thought I would pass along a thumbs up on this product given the ease of use and holding power.
Later Ed