BAC Forum
General Boards => Technical Support => Topic started by: Bob McCORMACK on January 09, 2013, 04:42:29 AM
-
When I pulled out the panel that contains the radio and the intellidrive console to change the audio unit the power and ground wires (red and black) to the intellidrive display console plug in the back of the console came out. They were never properly crimped. I can get them back in but the problem I have is which wire goes where.
They both are at the top of the plug but I am not sure which goes to the left (above the orange wire) and which goes to the right. I don't want to just try them to see what happens in case it does damage to the console if the power is fed in backwards.
Does anyone know how they go ?
Bob
-
Bob
Likely the reason you are getting little feedback on this is that most folks have changed the Intellidrive over to the Silverleaf. The benefits are great and it helps save fuel. We had Dean at Silverleaf install ours and he took our Intellidrive and gave us a good discount. He did the install too so most of us dont have much to go on for the wiring diagrams but Silverleaf might.
Best
Keith