BAC Forum

General Boards => Technical Support => Topic started by: Gary Carver on January 21, 2013, 03:25:11 PM

Title: ABS light is on
Post by: Gary Carver on January 21, 2013, 03:25:11 PM

Our ABS light is on and i have found the reset buttons and would like to know the codes and how to reset it

Title: Re: ABS light is on
Post by: Bill Sprague on January 21, 2013, 04:34:46 PM

Mine has come on because the sensor unplugs back by the wheel.  Beaver wired it so that extra wire in the harness was wrapped around the axle and the weigh of what remained would tug on the harness.  With enough tugging, it would unplug.  

Once plugged back in, the light went out.  I did not have to reset anything.

Title: Re: ABS light is on
Post by: Gerald Farris on January 21, 2013, 04:36:08 PM

Gary,
Since there were many different ABS systems installed on Beaver coaches over the last 20+ years, no one can answer your question without some information as to what coach you have. Normally the problem is a bad wheel speed sensor, or related wiring.

Gerald

Title: Re: ABS light is on
Post by: Karl Welhart on January 21, 2013, 04:47:00 PM

Check each sensor at the wheel hub to make sure something has not overheated, causing the sensor to melt....  This will cause the ABS light to come on and will also indicate you may have a serious brake problem.