BAC Forum

General Boards => Technical Support => Topic started by: Stan Simpson on April 26, 2013, 04:36:54 PM

Title: Aladdin reading on fresh water tank
Post by: Stan Simpson on April 26, 2013, 04:36:54 PM

We arrived yesterday at Shabbona Lake State Park, about 50 miles from home, for our shakedown trip. When filling the fresh water tank, I noticed the tank gauge in the water bay showed the tank as full. I went inside and checked the Aladdin and the gray water said zero, the black water said zero. The fresh water tank registered 489 gallons, and 489% of capacity. Wowzer! I finished filling the fresh water tank until the overflow started to dump water on the ground.

I got out the trusty manual, and it appears there is a code I need to re-set the baseline on the Aladdin. The manual indicates the code should only be used by a technician. How would the technician know the code? Is it available somewhere? Can I do it myself? Is there a chance the sensor is bad?

Thoughts, experiences, and suggestions anyone?

Thank you,

Stan

Title: Re: Aladdin reading on fresh water tank
Post by: Brad Burgess on April 26, 2013, 05:47:41 PM

Hi Stan

My Alladin code is either 1216 or 1218.

Brad Burgess
06 Monterey

Title: Re: Aladdin reading on fresh water tank
Post by: Joel Ashley on April 26, 2013, 09:34:56 PM

Mine does that regularly when topped off.  After some of it is used, it settles back to normal.  Never had to reset a with a code.  The waste tanks act the same way when too full.

Joel

Title: Re: Aladdin reading on fresh water tank
Post by: Stan Simpson on April 27, 2013, 04:54:17 PM

Quote from: Brad Burgess

Hi Stan

My Alladin code is either 1216 or 1218.

Brad Burgess
06 Monterey

Brad,

1218 did the trick, thanks!

Stan