BAC Forum
General Boards => Technical Support => Topic started by: Keith Moffett Co-Admin on May 15, 2013, 01:05:11 PM
-
I am tryng to isolate an air leak. I loose about 30 pounds over two hours and almost all the air over night.
I have covered most of the air lines around the two tanks using soap and water, no leaks at all.
Are there areas more likely than others? Any suggestions? If I find a leaking fitting or God forbid a pin hole what then?
Keith
-
Keith,
Mine leaks from the cylinder on the close out for the steps.
Pain to get to and I have not tackled that job, yet.
-
Our 1997 Patariot had a push in type manifold in front of the front axle that had one air in and four air out hoses. It started leaking on a trip to NC and the front suspension would bottom out.
Does your supension air bags deflate when the air leaks out? If either the front or rear deflates I would check those and the ride height valves. If the air supension does not deflate some have mentioned a pressure relief valve on the engine mounted air compressor.
If you are in a very quiet spot. Air up at night (when sound travels better) and walk arroud and under the coach and you may hear it.
-
You might also check your drain valve at the bottom of your air tank. I hunted for several weeks and then some one told me to be sure that was tight and it moved less than an 1/8 of a turn and the leak stopped.
-
Gerald Burns brings to mind the idea that your quick connect port, if you have one, might have a particle interfering with its closure/seal, or as he suggests, a purge port might be slightly skewed. Our coach has a "manifold" of 4 purge ports and a quick connect altogether in the battery bay, but many are located up front near the genset.
Joel
-
What I found on mine was the valves that control the ride height were composite bodied valves which were cracked and leaking air. Might want to check around those.
Good luck
Arden
-
Under the hood just below the passanger side windshield are a couple of connections. One is a manifold and goes partly to the floor slide panel. The other is an electronicaly controled module with one air in and one out. This unit is i/2 plastic electronic switch and 1/2 brass air fitting.
I have no idea what it does but the joint where plastic meets brass is leaking a fair amount. Guess I get to call Larry in BCS parts.
Hope this helps someone else
Keith