BAC Forum
General Boards => Technical Support => Topic started by: Jerry Carr on October 21, 2013, 12:53:59 AM
-
I have been having trouble getting into the coach using the touch entry pad, I may need to enter the code 5-6 times, it seems like it has lost it's sensitivity
I did check on a new pad with BCS ($240) they are very proud of these!! has anyone tried to clean the touch pad??
-
Jerry,
Had the same problem with my '04 Marquis. Corrosion inside the keypad. Had to order a new one. You could try calling Essex Electronics. That is who makes the keypad as far as I know 1-800-keyless. Their website for the keypad is http://www.keyless.com/KE-1700%20Main.htm . I think I was able to purchase just the keypad.
Steven Link
-
You may benefit from reviewing this previous thread, Jerry: http://forum.bacrallies.com/m-1361301756/s-0/highlight-Keypad/#num0
I've had mine replaced and it still acted up when wet, whether from rain or rinse water. BCS put sealant all around the pad plate-coach wall interface, and also the touch panel to plate interface. The only way moisture could get in was an inner wall leak. I've had no problems with it since. If you replace yours, Essex or Magnadyne, be sure the mounting is super sealed.
Joel
-
Just replaced ours and you can do it yourself. Bought on Ebay for 129.00 + shipping. The new came complete with all parts plus 2 keyfobs. When I pulled the old, the sticker on the inside stated it was made in 02/04 and the new had a sticker of 12/03. Plus yours and my old had the numbers horizontal and the new was meant to be read vertical but I installed to fit my opening. See photo .
-
Just installed a new key pad and now I need to find out how to get it programmed to work. Do you need to access the interior part of the system to program. If so where is it located as we cannot find. 2004 Marquis.
-
Doug: did the instruction booklet come with it? The button they are talking about is USUALLY located under the velcroed panel on your dash. I also had one attached to the keypad behind the panel by the pax side. I don't remember but I believe the one I installed this past spring did not have the button installed and it becomes a two person job to program. One at the keypad and one at he aforementioned velcroed panel. B the by, this was on an '05 Thunder. Marquis may be different.
-
Doug,
The programming button for the 04 Marquis is inside the shelf/ magazine rack next to the passenger seat. The best I remember I had to remove a wooden panel inside the magazine rack to access the programming button. I replaced the keypad on my 04 marquis and found the button there. Hope that helps.
Steven Link
-
Replaced ours 3 months ago. When I pulled the keypad the black button was attached to the pad side of the wiring harness The new came with a new button but not attached. I installed it like the original and programmed before putting everything back.
-
Steven, Our search will begin there, thanks.