BAC Forum

General Boards => Technical Support => Topic started by: charlie drake on February 12, 2010, 06:34:20 PM

Title: fuel gauge not reading correctly
Post by: charlie drake on February 12, 2010, 06:34:20 PM

I am having problem with my fuel gauge not reading correctly... flucuates from 1/4 to 3/4 tank then stays on 1/4--even though tank is full. please advice if possible. :)

Title: Re: fuel gauge not reading correctly
Post by: Gerald Farris on February 13, 2010, 01:44:50 AM

It sounds like you have a bad tank sending unit (sensor). If you can get to the tank unit, disconnect the hot wire to the sending unit and your dash gauge will go to full when the ignition is on, and empty when you ground the wire. If that is what happens, replace the tank unit (sensor).

Gerald

Title: Re: fuel gauge not reading correctly
Post by: charlie drake on February 16, 2010, 04:42:35 PM

thanks Gerald, I'll give it a try. charlie :)