BAC Forum

General Boards => Technical Support => Topic started by: Dan Murphy on July 19, 2014, 02:27:34 AM

Title: Side radiator access??
Post by: Dan Murphy on July 19, 2014, 02:27:34 AM

I have not been able to figure out how I can access the radiator on the 2009 Contessa. Can anyone offer a hint how I remove the panel in front so it can be cleaned?

Thanks
Dan

Title: Re: Side radiator access??
Post by: Joel Ashley on July 19, 2014, 09:09:15 AM

If your Contessa is anything like our Monterey, the grill swings up when you remove bolts in each lower corner.

Joel

Title: Re: Side radiator access??
Post by: Bill Sprague on July 19, 2014, 04:17:41 PM

If like mine, those bolts should be looked at anyway.  In 2004 Montereys, the bolts, screws and brackets there are pretty small for the size of the panel.  Vibration has caused mine to fail.  

Title: Re: Side radiator access??
Post by: Dan Murphy on July 20, 2014, 03:30:22 AM

I can find no bolts to loosen. I have looked all over and cannot figure out how to access behind the radiator cover.

Title: Re: Side radiator access??
Post by: Stan Simpson on July 20, 2014, 03:50:18 AM

Dan, keeping in mind that our coaches are different, mine are as shown in this picture. Look on the bottom of the "bay door". Its not really a bay door, but opens like one, with hinges at the top, and at the very bottom of the "door" where you cannot see without getting on your hands and knees are the bolts and nuts mentioned above. The "door" hinges are hidden. Took me awhile to figure it out too!  :)

Stan

Title: Re: Side radiator access??
Post by: Joel Ashley on July 20, 2014, 05:55:11 AM

Yup, I've only had mine open once, when the A/C fan fell loose.  To my recollection, the one bolt at the bottom back took a little doing to zero in on.  That's not to say your rig might be different than ours.  Hopefully someone with an '09 Contessa will chime in with definitive info.   Note the embarrassingly rusty bolthead under the corner of my also shamefully filthy louvered panel;  that bolt and one like it at the other end should be what you are looking for, unless your panel is fastened differently.

Joel