BAC Forum

General Boards => Technical Support => Topic started by: Ron Rivera on July 23, 2015, 04:19:38 AM

Title: Air conditioning
Post by: Ron Rivera on July 23, 2015, 04:19:38 AM

Need help!! I have a 2005 beaver Monterrey and sometimes the airconditioners turn on and sometimes they don't.  I don't know if it's a problem with the setting on the thermostats or what? I would appreciate your help.

Title: Re: Air conditioning
Post by: Steve Huber on July 23, 2015, 05:21:48 AM

Ron,
Are you hooked to shore power or have the generator running when trying to run the ACs? They will not run on the inverter. Also, what are your thermostat settings?
Steve

Title: Re: Air conditioning
Post by: Fred Brooks on July 23, 2015, 02:55:12 PM

                    Hi Ron,

              If you have a Comfort Control thermostat you may try performing a Reset on the Thermostat. This will erase all previous settings and reload the factory default settings and recognize all systems attached to it: IE air conditioners, heat pump, furnace, ect. To perform the reset: 1- turn the thermostat off. 2- depress mode and fan buttons and hold them down while you slide the bottom switch to the "on position". If the display says "FF" all is good. If the display says "EE" that means you have an error. The error could be the thermostat, wiring to the t-stat or the pc board in the front air conditioner.

             Hope this helps, Fred