BAC Forum

General Boards => Technical Support => Topic started by: Roy Lewis on September 09, 2016, 03:03:19 AM

Title: U Line icemaker
Post by: Roy Lewis on September 09, 2016, 03:03:19 AM

We have a 2002 Marquis 40 non tag with a U Line stand alone icemaker.  I have a clunking noise on shutdown of compressor. My question is how hard is it to pull icemaker and see whats going on.? I imagine a good vacuum job is in order! LOL

Title: Re: U Line icemakeru
Post by: Carol Moffett on September 09, 2016, 08:38:49 AM

Hello Roy!
   It is super easy to remove!  A hand full of screws from around the edge,  a bit of a tug and pop goes the weasel, so to speak! Lol!  We had to take ours out to fix a leak in the water line and we had no problems getting it out or putting it back in!
Carol  :^3=

Title: Re: U Line icemakeru
Post by: Roy Lewis on September 09, 2016, 06:08:48 PM

Thank you Carol, now if I proofed my question it wouldn't have read Icemakeru, LOL. Thank you so much for reply will pull it today!! :)

Title: Re: U Line icemakeru
Post by: Keith Moffett Co-Admin on September 09, 2016, 08:26:03 PM

Heads up Roy
your ice maker likely has enough slack in the water and power lines but if not you  may have access through the tall thin cabnet next to it.

Title: Re: U Line icemakeru
Post by: Roy Lewis on September 10, 2016, 04:16:09 AM

Thank you for reply!

Title: Re: U Line icemaker
Post by: Carol Moffett on September 11, 2016, 08:08:08 AM

Lol, consider it done Roy!