BAC Forum

General Boards => Technical Support => Topic started by: Dale Malquist on July 03, 2017, 05:16:57 PM

Title: Powergear Valid leveling
Post by: Dale Malquist on July 03, 2017, 05:16:57 PM

2007 Contessa.
When leveling using the hydraulic system the left rear raised by itself to extreme height. Twice. This resulted in the jack shaft being bent.
The new jack is installed however the control will not go into travel or otherwise operate. I think there is a leveling sensor/module in the rear of the coach that is the cause. Anyone been in this situation?

Title: Re: Powergear Valid leveling
Post by: Bryan Beamon on July 04, 2017, 12:20:11 AM

Dale, Valid tech support is in British Columbia. They are closed today because of Canada Day but open tuesday. They are very good and helped me in the past. FYI