BAC Forum

General Boards => Technical Support => Topic started by: Jason Worman on September 03, 2019, 04:40:55 AM

Title: Lighted door grab bar no longer lights uo
Post by: Jason Worman on September 03, 2019, 04:40:55 AM

Hi everyone

This might seem like a small thing but, the light in our clear grab bar by the door no longer lights up when the switch is turned on. Does anyone know how to replace the bulb/ repair?. It is a 1991 Contessa.

Thanks
Jason Worman

Title: Re: Lighted door grab bar no longer lights uo
Post by: Steve Huber on September 03, 2019, 05:44:00 PM

Jason,
Not clear whether it is an inside or outside bar. In either case remove the bar to access the bulb. Be sure to add new caulk strip to reseal the mount if it's an outside bar. Also make sure the seal where the bar fits into the bottom holder is in good shape. (I drilled a "weep hole" in the bottom of the holder to allow any moisture to drain out).
Steve

Title: Re: Lighted door grab bar no longer lights uo
Post by: Hal Grimshaw on September 03, 2019, 05:55:29 PM

mine is a 07 pt and the lights are on a long  4 to 6 inch wireing that goes into the side of the attachment.  I got them t cmping world.   very cheap ..each only a +/- dollar