I am not sure what you are asking for, but these are the specs I found in the Xantrex Trace 2512 SW manual. I copied and pasted the table, then tried to format it so that you can make sense of it.
================================================================
http://www.xantrex.com/documents/discontinued-products/sw2512mc-sw4024mc2userguide.pdfTable 6 on Page 104, Battery Charging: Charging Setpoints
TYPICAL BULK AND FLOAT SETPOINTS FOR COMMON BATTERY TYPES
Battery Type, Bulk Volts, Float Volts, Equalizing Charge Process
Sealed Gel
Lead Acid battery, 14.1 VDC BULK, 13.6 VDC FLOAT, Not Recommended - Consult manufacturer
A.G.M.
Lead Acid battery, 14.4 VDC BULK, 13.4 VDC FLOAT, Charge to 15.5 VDC or as per manufacturer
Maintenance-Free RV/Marine
Lead Calcium Battery 14.4 VDC BULK, 13.4 VDC FLOAT, Not Recommended - Consult manufacturer
Deep-Cycle, Liquid Electrolyte
Lead Antimony Battery 14.6 VDC BULK, 13.4 VDC FLOAT, Charge to 15.8 VDC or as per manufacturer
NiCad or NiFe Alkaline Battery*
(using 10 cells in series) 16.0 VDC BULK, 14.5 VDC FLOAT, Consult manufacturer
Note: Values shown are for 12 volt systems. For 24 volt systems multiply the settings shown by 2. For
48 volt systems multiply the settings shown by 4. These settings are guidelines, refer to your
battery manufacturer for specific settings